loop method造句
例句與造句
- Plastics . sheets . estimate of flexibility . suspended loop method
塑料制品.薄板.柔性評估.吊環法 - Analysis of signal character of magnetic flux leakage testing using loop method
線圈法漏磁探傷的信號特性分析 - Rubber or plastics coated fabrics determination of flexibility - flat loop method
橡膠或塑料涂覆織物.柔軟性的測定.扁環法 - Motion analysis of the dual - elbow - bar mechanism of the die - cutting machine based on the loop method
基于回路法的模切機雙肘桿機構運動分析 - The development is consists with the thinking of software engineering and the loop method of prototype
文中對系統的硬件和軟件解決方案進行了詳細的討論。 - It's difficult to find loop method in a sentence. 用loop method造句挺難的
- A feedforward or open loop method is used to estimate the parameters , and then more accurate feedback or closed loop method is used to complete synchronization
首先利用前向估測方法對參數進行預估計，在此基礎上結合后向反饋方法完成同步。 - By means of the multi - loop method , the steady - state analysis of internal faults in stator windings of synchronous machine has been made , but as to the transient analysis , research only limited to single machine with no - load
運用多回路方法，已經基本解決了同步電機內部故障的穩態分析問題，但對故障的暫態研究，以前還僅限于單機空載的情況。 - Regarding the discrete magnetic vector potential and loop currents as the state variables , and combining the fem with the multi - loop method , a mathematical model of the synchronous machine with internal faults is set up in this paper
本文以矢量磁位和回路電流為求解變量，把電機的電磁場方程與反映繞組聯接情況的電路方程聯立起來同時求解，提出了同步發電機定子繞組內部故障的瞬態電磁場與多回路耦合的數學模型。 - The paper ' s contents involve the following aspects : 1 based on the multi - loop method , this paper describes the construction of a mathematical model of salient - pole synchronous generators suitable for analyzing the transient behavior of internal faults in stator windings
本文針對發電機定子繞組內部故障暫態分析中存在的一系列問題，開展了研究工作，主要內容有： ( 1 )建立了凸極同步發電機定子繞組內部故障暫態計算的多回路數學模型。 - To solve the poor precision problems of dataglove angle outputs , this paper builds human hand kinematic model and fingertip position error model , and gets the precise parameters of human hand model by the parameters identification based on fingertip positions closed loop method
本文針對數據手套關節角度輸出精度低等缺點,建立了人手的運動學模型和各指尖位置的誤差模型?；谥讣馕恢瞄]環的方法完成了人手模型的參數識別,提高了人手模型幾何參數的精度,得到了較精確的人手手指指尖位置。 - Based on extended kalman filter ( ekf ) algorithm , an traditional attitude determination scheme using star sensors and gyros was studied , and proved not able to achieve the required precision . so a new idea called instrument - in - loop was presented what using the attitude information contained in the payload ' s data for the control loop . the simulation proved that the instrument - in - loop method can greatly improve the precision of attitude determination with low cost
建立了svom衛星各種姿態敏感器的測量模型，研究了基于推廣卡爾曼濾波算法的“星敏感器+光纖陀螺”定姿方案，指出了其無法滿足svom衛星的定姿精度要求，并提出了instrument - in - loop的思想，即利用衛星有效載荷測量數據中蘊含的高精度姿態信息來濾波定姿，從而在避免使用昂貴的星敏感器的同時大大提高了系統的定姿精度。